Content deleted Content added
I made delay wire scheme improve it |
m Finished dlaywire autoreactor |
||
| Line 9: | Line 9: | ||
== Delay wire auto reactor == |
== Delay wire auto reactor == |
||
[[File:Delay wire autoreactor.png|thumb|350x350px|A working delay wire autoreactor they have many types u can even do line with tons of autoreactors or try use polysilicon frequency]] |
[[File:Delay wire autoreactor.png|thumb|350x350px|A working delay wire autoreactor they have many types u can even do line with tons of autoreactors or try use polysilicon frequency]] |
||
I will finish this in next few minutes |
|||
Delay wire reactors are easiest and cheapest |
Delay wire reactors are easiest and cheapest |
||
For first you need make temperature control, put 2 temperature sensors on reactor and put polysilicon on them both. After config left one to 0:1000 and its polysilicon be deactivate, and on right one put 1000:inf and dont change poly |
|||
You need to put 2 temp sensors connected to polysilicon |
|||
[[File:Scheme of delay wire autoreactor.png|thumb|Scheme of delay wire autoreactor red is transformer black is delay wire gray is dispencer orange is trigger wire green is flip flop poly and yellow is reactor]] |
[[File:Scheme of delay wire autoreactor.png|thumb|Scheme of delay wire autoreactor red is transformer black is delay wire gray is dispencer orange is trigger wire green is flip flop poly and yellow is reactor]] |
||
A sensor set to 0:1000 that sends signals through a blue polysilicon (Mode 1) will lower the rods when the temperature is between 0F and 1000F, increasing temperature. The opposite can be done with a pink polysilicon (Mode 0) and a 1000:1230 temperature range, which will raise them when the temperature is between 1000F and 1230F, therefore decreasing the temperature. The reactor will explode at 1200F, so the pink polysilicon is absolutely necessary. |
|||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||